Hotchkis 2278 2004-2006 GTO Sport Sway Bars Manuel d'utilisateur

Anti-roll bar set (pn 2278) Pontiac GTO Thank you for your purchase from our new line of GTO parts. Please call us at (877) 4NO-ROLL

Tools Required for this Installation - 4 post lift or alignment rack with center jacks - Pry bar - Transmission jack - The following sockets or wr

4) Slowly lower the transmission jack and let the differential and rear cradle frame tip downward. 5) Next, detach the endlinks from the sway

7) Remove the stock sway bar from the vehicle through either side of the differential. 8) Set the Hotchkis sway bar next to the stock sway b

9) Lube the inside hole of the Hotchkis polyurethane bushings with the included grease. 10) Open the bushing and push it over the bar. Make sur

12) Reinsert the Hotchkis sway bar is the same manner as the stock bar came out. 13) Repeat steps 2-6 in reverse order to complete the installation

Anti-roll bar set (pn 2278) Pontiac GTO Hotchkis P/N Item Description Quantity1 22800286 Front Anti-Roll Bar 12 22900286 Rear Anti-Roll Ba

Hotchkis Performance LLC Return Policy & Limited Warranty Effective December 1, 2010 all Hotchkis products must be registered to qualif

THERE ARE NO WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, WHICH EXTEND B

2) Remove the 4 bolts that secure the skid plate using a 13mm socket. 3) Next, disconnect the sway bar endlink from the bar using a 14mm socket

5) You will now disconnect the cradle frame from the vehicle by removing the 2 front bolts and 2 rear bolts using a 16mm and 18mm socket respectivel

You will notice that the hard transmission lines lay on top of the coolant/transmission line bracket mounts. Make sure to move the transmissio

Then disconnect the soft hose from the hard line slowly. Once disconnected, connect the one end of the 3/8” hose to the hard line. Plug the soft tra

10) The bar can finally be removed from the vehicle. The sway bar will have to come out through the front, but it will take some patience to do

11) Place the Hotchkis sway bar next to the stock sway bar to setup proper orientation. This is done to avoid putting the sway bar in upside. 12)

14) Open the bushing and push it over the bar. Make sure the flat side is facing up and the split is in the front. 15) Next, grab the Hotchkis s

Special tip: Use a large pry bar when trying to re-align the cradle frame holes with the body. You want to be able to start each bolt by hand first.