Hotchkis 32101 Tools, Trailing Arm Bushing Install and Remo Manuel d'utilisateur télécharger pdf

Bushing Removal

Be sure to clean the mount and old bushing. Use a penetrating oil to aid in removal.

Step 1: To remove the bushing, place the tool on the

rear of the bushing mount with the larger disk on the

opposite side. Spray penetrating oil on the bushing shell.

Step 2: Tighten nut until the large disk is up against the

bushing mount.

Bushing Removal/Installer Kit

32101

LARGE DISK

1 2 3 4

Bushing Removal Be sure to clean the mount and old bushing. Use a penetrating oil to aid in removal. Step 1: To remove the bushing, place the too

Page 2

Step 3: Replace the large disk with the smaller disk. This disk will fit inside the bushing mount hole and allow you to remove the bushing comple

Bushing Installation Be sure the bushing mount hole is clean and free of burs before installation.NOTE: Bushings should be installed as shown.

Page 4

Pas de commentaire

Hotchkis 32101 Tools, Trailing Arm Bushing Install and Remo Manuel d'utilisateur