Hotchkis 2253 Sway Bars, Set, 65-66 GM B-Body, Sport Manuel d'utilisateur

2253 FRONT AND REAR SPORT SWAY BAR SET 65-66 CHEVROLET B-BODY Thank you for your purchase from our line of classic Chevrolet B-body suspensio

10) Unbolt the bracket from the end link. Hold the bracket back up in position to the bolts hanging from the frame. Use the nylock nuts included to h

65-66 Chevrolet B-body Sway Bar Kit, Parts List P/N 2253 Hotchkis P/N Item DescriptionQuantity per kit1 22810006 Front Sway Bar, 65-70 Chevrolet B-bo

CHECK OUT EVERYTHING ELSE HOTCHKIS PERFORMANCE MAKES FOR YOUR 65-70 B-BODY CHEVROLET!! Double adjustable panhard rod to positively locate your axle

Hotchkis Performance LLC Return Policy & Limited Warranty Effective December 1, 2010 all Hotchkis products must be registered to qualify for

of any salesperson do not constitute part of this limited warranty and cannot be relied upon as a warranty. THERE ARE NO WARRANTIES, EXPRESSED OR IMP

Hotchkis Performance will not accept product returns without the RGA number, receipt and the information described above. C.O.D. or collect shipments

3) Turn the front wheels to point straight ahead. If you jacked up the front of the vehicle, you should now lower the vehicle so that the weight is o

5) The end of the bar on the driver’s side should now be free. Pull the end of the bar towards the front bumper and rotate as necessary to remove th

7) Slide the end of the Hotchkis bar between the coil spring and the brake drum in the same fashion as was used to remove the stock bar. The

8) Use the grease pack provided to put a heavy coat of grease on the inside of the sway bar bushings. Place the bushings over the bar with the cut in

11) Use the 3/8” bolts from hardware kit #1735 to attach the Hotchkis bar. Drop the bolts down through the drilled out holes in the frame. Start the

Please call us at (877) 4NO-ROLL if you have any questions regarding your Hotchkis Performance products. This installation will require drilling new

4) Use the grease provided to apply a heavy coat of grease to the sides of the bushings on the “dog bone” end links. Attach the mounting brackets to

7) Snug down the hardware connecting the end links and brackets to the bar. Do not fully tighten the hardware at this stage. You should still be able